Brand new aftermarket Stator Crankcase Cover Gasket Mosfet Voltage Regulator Kit Direct replacement to your original unit Plug-and-play, direct fit, easy installation All shipped products are tested We have even included the opposite connector (main harness side) as we know these are often melted / corroded/defective and a major cause of repetitive electrical issues. All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part. Stator Highest grade of lamination materials Highest grade of copper winding, resistant to 200 degrees Celsius Stator crankcase cover gasket included Connector included Rubber grommet included Brand new RMSTATOR Red Machined Aluminum Mosfet Regulator Our new RMSTATOR machined aluminum Mosfet voltage regulator is a great upgrade for heat dissipation in any powersports charging system. After 10 minutes of use, our billet aluminum heatsink runs cooler by 33% than standard cast regulator housings. Our new RMSTATOR red regulator, equipped with the renowned Mosfet regulation technology, is an added value to any three-phase permanent magnet charging system. STOP BURNING YOUR REGULATOR RECTIFIER!It is time to update or replace your voltage regulator with the advanced MOSFET type.It runs cooler than all OEM diode-style regulators. In addition, this rectifier has overheat protection, rather than burn up, it will simply turn off for a while and cool off. The quality exceeds the OEM equipment Improved heat sink and charging capabilities Higher grade of electric components Stator dimension Interior diameter: 38 mmExterior diameter: 107 mmThickness: 12 mmLength of wires stator to grommet: 160 mmLength of wires grommet to plug: 330 mm Other specifications:Number of wires:3Number of plugs: 1Number of pins: 3 Wire to wire resistance:Alternator: Yellow to Yellow = 0.5 ohms /-20% Regulator dimension Width : 92 mmLength: 92 mmHeight: 30 mmFixation holes center to center: 75 mmWires length: 300 mm Other specifications :Number of plugs: 2Number of pins: 7Number of wires: 7Minimum Charging Voltage: 14.5 V /- 0.5 VMaximum Charging Current: 50 A / 500 WOpen Circuit Voltage: Reviews There are no reviews yet. Be the first to review “STATOR CNC MOSFET KIT GSXR600/750 06-19 (RMS900-107319)” Cancel replyYour email address will not be published. Required fields are marked *Your rating * Rate… Perfect Good Average Not that bad Very poor Your review *Name * Email * Save my name, email, and website in this browser for the next time I comment.
